|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
12-04-2009, 02:02 PM
|
|||
|
|||
|
I need an intake manifold
Does anyone know where I can get a performance intake manifold for a:
1997 K1500 350 VIN-K TBI injection I've looked around a little bit online for a friend but haven't been able to find anything except for stock manifolds, and he doesn't want to put a stock one on and Edelbrock doesn't have one for his truck. Any suggestions? Red 
|
|
#2
12-04-2009, 03:40 PM
|
||||
|
||||
|
Re: I need an intake manifold
The odd thing is that your friend's truck is 1997 AND TBI. Chevy trucks 1996 and later started using CSFI to help comply with OBD-II requirements...better check and make sure.
Edelbrock does make an intake manifold for the 350 EGR-equipped TBI engine, Part # 3704. http://www.edelbrock.com/automotive_...rmer-tbi.shtml Hope this helps!
__________________
Current Garage: 2009 Honda CR-V EX 2006 Mazda 3i 2004 Chevrolet Silverado 2500HD 2003 GMC Envoy XL 2000 Honda ST1100 2000 Pontiac Sunfire Vehicle History: 2003 Pontiac Vibe AWD - 1999 Acura Integra GS - 2004 4.7L Dakota Quad Cab 4x4 - 1996 GMC Jimmy 4wd - 1995 Chevrolet C2500 - 1992 Toyota Camry LE 2.2L - 1992 Chevrolet S10 Ext. Cab 4.3L - 1995 Honda ST1100 - 1980 Yamaha XS400 - 1980 Mercury Bobcat.
|
|
#3
12-06-2009, 08:02 PM
|
|||
|
|||
|
Re: I need an intake manifold
Thanks for the link after I got off work I went over to look at it and its not throttle body injection, he apparently didn't know what TBI was.
|
|
#4
12-24-2009, 02:19 PM
|
|||
|
|||
|
Re: I need an intake manifold
on a 97 I think you have the 5.7 vortec engine...I don't think there are any aftermarket performance intake manifolds for this engine...if you plan to stay with stock fuel injection?
__________________
----------------- Elbert Clarke
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
