|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
07-05-2007, 06:09 PM
|
|||
|
|||
|
Trans Am Drive shafts..
79 TransAm w/301 and 4-speed. I swapped out the 301 for a 400. There are a quite a few allignment/clearence issues due to the fact the the 400 sit's about 2 inches up and forward. The driveshaft yoke only goes about half way into the back of the transmission. Get a longer driveshaft, or have this one lengthened? I've never delt w/them before. Also, are adjustments to the shifter linkage necessary/possible?
|
|
#2
07-05-2007, 07:07 PM
|
|||
|
|||
|
Re: Trans Am Drive shafts..
A good driveshaft shop can make up a new longer tube using your ends. If the shift linkage reaches you may be able to get it to work, this is trial and error.
__________________
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
