|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
05-08-2007, 03:18 PM
|
|||
|
|||
|
Crankshaft Position Sensor 1997 PA
I am going to replace the Crankshaft Position sensor on my 1997 Park Ave. My question for the board is regading installation of the new sensor - Is the new sensor simply bolted in place - or is there some type of alignment needed? I also understand the balancer has to be removed. Any comments on this are appreciated - thanks
|
|
#2
05-08-2007, 07:26 PM
|
||||
|
||||
|
Re: Crankshaft Position Sensor 1997 PA
Quote:
__________________
Knowledge can be communicated, but not wisdom!   
|
|
#3
05-10-2007, 01:08 AM
|
|||
|
|||
|
Re: Crankshaft Position Sensor 1997 PA
Do you know if the balancer is a press fit on the crankshaft like an older small block chevy or does it slide off easily after the bolt is removed? thanks
|
|
#4
05-10-2007, 12:46 PM
|
||||
|
||||
|
Re: Crankshaft Position Sensor 1997 PA
Yes, it is a press fit and you will need a puller simlar to one shown in the link: Click Here
BTW, it helps to have a harmonic balancer installer, when you put it back on!
__________________
Knowledge can be communicated, but not wisdom!
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
