|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
04-06-2007, 05:49 PM
|
|||
|
|||
|
95 caprice 4l60e swap to a th350
i have a 95 caprice with a 4l60e tranny that is bad, i will rebuild when i can take a transmssion rebuil class in sept. Meanwhile i have a th35o in my garage that i wanna install till sept. I know it will bolt up and i know i might have driveline issues and trans mount issues thats fine, but by not having the 4l60e trans wire harness not pluged in will this cause a problem? no speedo is ok with me
|
|
#2
04-06-2007, 05:56 PM
|
||||
|
||||
|
Re: 95 caprice 4l60e swap to a th350
Since the PCM on that car is designed to work with both the engine and transmission, I would think you would spend more money to get the TH350 to work with it, than to rebuild the 4L60E or even get one from a junkyard, even if the TH350 was given to you for free.
__________________
1988 9C1 - Modified LM1 @ 275HP/350TQ - TH700R4 - 3.08 8.5" Disc Rear - see it at http://www.silicon212.org/9c1! 2005 Crown Vic P71 - former AZ DPS - 4.6 liters of pure creamy slothness! 1967 El Camino L79/M20 old school asphalt raper Remember - a government that is strong enough to give you everything you need, is also strong enough to take everything you have.
|
|
#3
04-06-2007, 09:40 PM
|
||||
|
||||
|
Re: 95 caprice 4l60e swap to a th350
You could rebuild it now, so you can ask a lot more educated/experienced questions in your autumn class. Get an ATSG manual for the 4L60E and have at it.
|
|
#4
04-07-2007, 05:26 AM
|
|||
|
|||
|
Re: 95 caprice 4l60e swap to a th350
Ditto to the above comments. Yo be time and money ahead if you just rebuild it now.
__________________
CD 1991 W41 #142 1989 Caprice 9C1 1997 C1500 1997 Bonnie SE 1998 Olds 98 LS Recently updated: http://forums.b-body.org
|
|
#6
04-07-2007, 07:43 PM
|
||||
|
||||
|
Re: 95 caprice 4l60e swap to a th350
There are a lot of parts, but it isn't difficult. Mainly pay attention to things such as end play, clutch stack thickness, gasket and ball valve placement, etc.
__________________
1988 9C1 - Modified LM1 @ 275HP/350TQ - TH700R4 - 3.08 8.5" Disc Rear - see it at http://www.silicon212.org/9c1! 2005 Crown Vic P71 - former AZ DPS - 4.6 liters of pure creamy slothness! 1967 El Camino L79/M20 old school asphalt raper Remember - a government that is strong enough to give you everything you need, is also strong enough to take everything you have.
|
|
#7
04-07-2007, 09:32 PM
|
||||
|
||||
|
Re: 95 caprice 4l60e swap to a th350
Thumb through this article and you'll get an idea - Then get a manual. It'll be the best $15 you'll ever spend on a transmission:
4L60E Repairs
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
