|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#2
10-15-2006, 10:26 PM
|
||||
|
||||
|
Re: rod pistons and crank combo's
No. they'll be stick out of the block at tdc. I also think C's have a differnt bearing size, not possative on this... either way they are too long.
__________________
 
|
|
#3
10-15-2006, 11:37 PM
|
||||
|
||||
|
Re: rod pistons and crank combo's
B16 rods are shorter than GSR rods aren't they?? So as i understand him, you would actually lower compression by doing that....maybe i'm the one reading this all wrong.
I know that the GSR has a longer stroke, but the same bore...
__________________
2015 DGM STi - 2006 SGM STi - 1999 Built/boosted GSR
|
|
#4
10-16-2006, 12:06 AM
|
||||
|
||||
|
Re: rod pistons and crank combo's
All B series are the same bore, as are most all honda series engines. The displacement is changed by the stroke, when you increase the stroke, from say 1.6 to 1.8 liters you have to shorten the rods and/or the compression height of the pistons. By installing 1.6 pistons/rods on a 1.8 crank you end up with rod/pistons that are too long for that crank.
__________________
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
rod pistons and crank combo's
