'94 G20 AC/Heater Fan

mdhoff · #1 03-14-2006, 10:37 PM

'94 G20 AC/Heater fan only runs on 4/high will not run on 1/low 2/mid or 3/mid-high. Is it the fan motor or switch or something else. Thanks for any help you can give.

mdhoff · #2 03-14-2006, 10:44 PM

DAH! just read Readingsaint's post with the same prob. must be the resistor. Is the resistor located at the fan motor?

Thanks again.

speediva · #3 03-26-2006, 05:33 PM

The blower motor resistor is over on the passenger side in the foot well under the glove box. Look in one of the other thread about replacing it. It's a VERY common problem on the P10 G20s.

POST REPLY TO THIS THREAD