|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
07-02-2002, 09:00 PM
|
||||
|
||||
|
Putting an H22 into a 97 Accord
Got a ? If you had a 97 Honda Accord and were swapping an H22A into it, what genration would you swap? OBD 1 or OBD 2??? Give reasons why or why not to support your statement..... I'm just curious what you all would do.... Thanks
|
|
#2
07-02-2002, 09:37 PM
|
|||
|
|||
|
I know I know, i say this a lot, and sometimes it helps, but go to www.H22A.org, they are somewhat informative on 4th and 5th gen h22 swaps
__________________
so far: 1990 accord ex JDM F22B DOHC/Nakayama cold air intake/Nakayama exhaust/18" Enkei Zoku painted black/Yokohama Parada Spec II/Full air ride/shaved doors & mouldings/VIS R34 front bumper blah blah blah...
|
|
#3
07-03-2002, 09:34 AM
|
||||
|
||||
|
i don't know where you live if you need to have emissions testing done. if you do then you will need to swap a odb2 engine in it. and for the most states it's illegal to swap an older engine into a car, or to swap an engine with morew miles than the original engine had
__________________
hondaman-iac @ HondaStyle 92 ACCORD LX -- powered by a blown F22A1 Current Mods: *rear lower tiebar *AEM CAI *Koni Yellow Struts *Ground Control coilovers *Energy suspension bushing kit *front upper strut bar *rear upper strut bar PureHonda member since April 2001
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
