Installing Amp

[Batznight]

Hi all I got a Concorde '99 or '00 don't know, well i was installing the amp and when i needed to put the power cable from the trunk to the batery, but i can't find a hole to put it from the there to the engine, can anyone help me plz, thats all i need to know, ty.

[Bizzy102]

You Gotta Make One If You Don't See Any

[Batznight]

ok thx

[blackdragon258]

If I remember right, I ran mine along with a brake line or the power steering. Either way, you need to run it through an existing hole in the firewall. No easy way to do it.

[Batznight]

Yeah I installed it, thx people, I did what blackdragon said, I found a existing hole in the firewall where the brakes are. Thx.

[JustinGoodie]

Originally Posted by Batznight

Yeah I installed it, thx people, I did what blackdragon said, I found a existing hole in the firewall where the brakes are. Thx.

I've gotta run 4 gauge and i was looking for a hole to run it through... i saw the hole you're talking about, but i couldn't find the other side of it... is it very accessible?? i pushed a screwdriver through there but i couldn't see it coming through the other side, and as far as i can tell, it's gotta exit underneath the master cylinder.

maybe i'm just getting frustrated, but i can't tell where that hole goes

[passwarrenty]

run your cable from the engine compartment to passenger door there is a small opening that it can fit by the door hinge there is a rubber plug that get you in the car then run it under your door trim inside when you get to the back sit run it to the trunk did it on my 02 concorde

[nktidwel]

The hole come out behind the plastic in the wheel well. Just did mine yesterday.