|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
|
|||
|
|||
|
Such A Noob Question
Guys since I've been on the forum the last couple days...I noticed the most talked about things are the motors..305 and 350....well what do those numbers mean? I havent gotten into the motor side of cars really yet at all...just moslty audio and drivin fast :P Anyways if you guys could clear this up for me that would be fantasic
__________________
1992 Grand Prix - Blown Motor 1990 Aerostar - Blown Motor 1999 Venture - Blown Motor/Blown Tranny Next on the List.... |
|
#2
|
||||
|
||||
|
Re: Such A Noob Question
305 or 350 cubic inches displacement is what we mean... just different ways of measuring, 305= 5.0 liters of displacement 350= 5.7...
the displacement of an engine is determined by the volume displaced by the piston as it moves up in the cylinder
__________________
'92 RS lt1/t56, lt4 hot cam, 30lb injectors, 54mm throttle body, full exhaust, 4.11 posi, 4 coil ignition, alluminum driveshaft, adj rear suspension, low. springs, electric water pump, custom tune. |
|
#3
|
||||
|
||||
|
Re: Such A Noob Question
different sizes of cylinder bores and stroke of the crank will determine the displacement.
__________________
|
|
#4
|
||||
|
||||
|
Re: Such A Noob Question
Quote:
|
|
#5
|
|||
|
|||
|
Re: Such A Noob Question
if your get the i-roc don't blow the motor in it treat it like your baby lol
__________________
355 small block 4 bolt, 700R4 tranny/w shift kit, elbrock 650 carb, elbrock intake, mild cam, 3.73 posi rear end, 3" cowl hood, 3" exhust, b&m mega shifter, k&n air filter, ac delete
|
|
#6
|
||||
|
||||
|
Re: Such A Noob Question
a 350 has a 4 inch bore and a 3.48" stroke...a 305 has a 3.736 bore and a 3.48 stroke and the ls1 has a 3.9 bore and 3.62 or 3.625 stroke and is 346 cubic inches.
|
|
#7
|
|||
|
|||
|
Re: Such A Noob Question
Quote:
Well with my Grand Prix I was taking it off roading and when I got it stuck I would just floor it and have a buddy push (only paid $300 for the car so I didnt care much about it) Also with the Aerostar my family ran that van hard. Rolled the odomitor once and was half way to doing it again in about 5 years hehe. An the venture..well the oil pumped went while we were on the highway which put a piston through the block(i think thats what the guy at the shop said) An the tranny wouldnt shift outta OD at all so lol it blew quick lmao
__________________
1992 Grand Prix - Blown Motor 1990 Aerostar - Blown Motor 1999 Venture - Blown Motor/Blown Tranny Next on the List.... |
|
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|