ok...im lazy and dont wanna pay to install the subs...

[Chiquae07]

i just bought some kenwoods and a 920w amp pak with a box. since i have a b15 sentra se, there is a factory sub. can i just disconnect it and how would i set up the wiring the proper way without having to drill holes in my firewall?

can i just run the cord through the dash and under the floor carpet. also how do i get the frequency to my amp...do i really have to sauder/strip and tape together my speaker wires to get the frequency to the amp or is there an easier way? thanks.

[nismo_pilot]

http://www.automotiveforums.com/vbul...nstalling+subs

[slideways...]

leave the sub in connect it like a speaker
just run the cords thru a hole in the firewall thats already there. for instance the hole for the wiring harness.

actually what you should do is since the factory sub is a 6.5", and there is a spot for it on both sides, you should buy 4 6.5s and wire them all to a 4channel amp. that would be sick. or id bet with some careful cutting you could fit two 6x9s in the stock speaker housings and make it look clean as hell.

[Chiquae07]

lol....im planning on setting it up to have each sub pushin like 460w @ 4 ohms....but i need to find somewhere that i can get two 2gauge wires that are like 17 ft long each to power the 2 amps. kinda gotta build my own amp kit kinda sorta. i did think of what u said before, but i diddnt really wanna get into customizing and drilling into it.