|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| JDM Motor & Parts info/chat Discussions on Mugen, Spoon etc. Plus, info on motor swaps (b18 's, b16's h22's etc) and other JDM info! |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
12-01-2005, 12:43 PM
|
|||
|
|||
integra engine swap
I have a 94 LS with 190k and a blown head gasket. Im lookin to swap out the engine and the car is an automatic. Im wondering if I get a b18c1 from a newer gsr, are there any automatic trannys that will fit? If not Im stuck with the b18b1, which is cheaper, so how can I make a little extra power with that?
|
|
#2
12-01-2005, 01:09 PM
|
|||
|
|||
|
Re: integra engine swap
the b18b1 is a remove and replace. the gsr will require a few more modifications and will be 3 times the amount it will cost to simply just swap out the longblock on the ls chassis.
swapping out the headgasket is the easiest route.
__________________
99 [email protected] psi si- I voted for the Terminator for Gov. 95 HB- B16a2- SC34@12psi WTB: USDM B16a2 or B16a3 complete short block. pm is the key. FS: B series InlinePro cast mani, PnH RC 550s, and Hondata S2b. pm me.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
