|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
![]() |
Show Printable Version |
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
|
||||
|
||||
|
Oil pressure might be low and I have a little leak.
When I was last at the shop they discovred a tiny oil leak, not on the transfercase or pan or transaxle, somwhere up in the engine.. There is never any oil in the driveway at all and the ammount of oil never drops at all on the dipstick but its still there a little, when they mentioned that I said that I thought the pressure might be a little low since it seemed lower on this car than on the SL I had. They hooked it up to a real oil pressure gauge and they said that it was just within spec and that they wanted to go in and find out what was leaking, I think they wanted to check the pump too. The oil gauge if left at idle for a little while is like 2-3 of the small bars from the bottom which seems very low to me, at regular driving RPM (like 2k) its around the middle near the first thick bar from the bottom, when I rev it up a bit it rises a little from there. Should I be worried, I don't have the money for them to disect my car let alone replace anything, I've got just enough to buy a downpipe which will fix the ricy sound and I'd prefer to do that instead of saving up to fix a problem that might not even be a reality.
__________________
1995 3000GT VR-4 Installed: ESP front precat eliminating downpipe, test pipe, RF-1008 K&N, Dejon tool Y pipe, 1G DSM BOV, MSD wires, Guted rear pre cat, ISSPRO EV Marine boost gauge, IPO MBC, EGR blockoffs, Palm m515 dataloger setup, NGK iridium plugs, SPEC stage II clutch 500ft/lb, 5300k HID plug and play setup. Soon:Topline Engineering ground wires. |
|
#2
|
||||
|
||||
|
Re: Oil pressure might be low and I have a little leak.
If the oil pressure is raising when you are reving it up, there might be some kind of bad connection with your gas and that guage.. although if there is a leak.. and you know about it that might even be the problem. You should get it looked at, because if you run low on oil, dont know about it, you could easily blow your engine in no time. Just trying to help, may be right or might not be.
__________________
![]() 1991 Dodge Stealth R/t |
|
#3
|
|||
|
|||
|
Re: Oil pressure might be low and I have a little leak.
Your oil presure will be low at idle, esp on the stock gauge. As long as its not all the way at the bottom during idle your fine. I think mind was just above the first large mark when crusing.
__________________
A few "bolt on" mods, a couple "cut, smash, hammer, weld, etc" mods, and a couple "why the hell do I need this/what the hell is this" weight reductions. |
|
#4
|
||||
|
||||
|
Re: Oil pressure might be low and I have a little leak.
my car has the same problem. a small leak, but i see no oil leak from th bottom, no matter how long i lay on the ground and watch. but it was loosing oil a little to quick, so i knew it had a leak, just didnt know were it was coming from. eventually i found it started driping from the.............the..........i'm sleepy, i cant even remember the name of it, the damn seals from the....
the hell with this i'm going to sleep. i'll tell you in the morning
__________________
|
|
#5
|
||||
|
||||
|
Re: Oil pressure might be low and I have a little leak.
Lol, I'll take a pic of it at idle later on, I want to change the rear plugs and wires today.
__________________
1995 3000GT VR-4 Installed: ESP front precat eliminating downpipe, test pipe, RF-1008 K&N, Dejon tool Y pipe, 1G DSM BOV, MSD wires, Guted rear pre cat, ISSPRO EV Marine boost gauge, IPO MBC, EGR blockoffs, Palm m515 dataloger setup, NGK iridium plugs, SPEC stage II clutch 500ft/lb, 5300k HID plug and play setup. Soon:Topline Engineering ground wires. |
|
#6
|
||||
|
||||
|
Re: Oil pressure might be low and I have a little leak.
Does the 3000 GT or the Stealth burn oil like crazy? Or.. would that be a leak like you guys are talking about...?
__________________
![]() 1991 Dodge Stealth R/t |
|
#7
|
|||
|
|||
|
Re: Oil pressure might be low and I have a little leak.
i know alot of the 3000GTs have oil leaks from the oil cap... it seems to me that my boyfriends 95 3000GT SL oil pressure seems really low at least thats what the guage reads but then again you can never tell since theres no acual numbers on the guage haha
__________________
Quote:
|
|
#8
|
||||
|
||||
|
Re: Re: Oil pressure might be low and I have a little leak.
Quote:
__________________
1995 3000GT VR-4 Installed: ESP front precat eliminating downpipe, test pipe, RF-1008 K&N, Dejon tool Y pipe, 1G DSM BOV, MSD wires, Guted rear pre cat, ISSPRO EV Marine boost gauge, IPO MBC, EGR blockoffs, Palm m515 dataloger setup, NGK iridium plugs, SPEC stage II clutch 500ft/lb, 5300k HID plug and play setup. Soon:Topline Engineering ground wires. |
|
#9
|
||||
|
||||
|
Re: Oil pressure might be low and I have a little leak.
the valve covers, thats where the oil was leaking from. and the oil cap
__________________
|
|
#10
|
||||
|
||||
|
I had a slow leak from the oil cooler a few years back. One of the hoses had a small crack in it.
__________________
Resistance Is Futile (If < 1ohm) |
|
#11
|
||||
|
||||
|
Re: Oil pressure might be low and I have a little leak.
i have a leak in my front valve cover, which is getting fixed soon. parts/labor is $100
__________________
'92 3000GT VR4 Current Mods: K&N FIPK RPS Streetmax clutch Rebuilt tranny Free Boost Mod Maximal Performance Solid Motor Mounts Pictures and Videos of my car Got a question about your auto insurance? I'm an insurance agent, ask away. |
|
#12
|
|||
|
|||
|
Re: Oil pressure might be low and I have a little leak.
Mine comes from my oil cap because there's always a nice spot of fresh oil around the area. Don't really know what I could do to get rid of it... :o/
|
|
#13
|
||||
|
||||
|
Re: Oil pressure might be low and I have a little leak.
The cap isn't very leaky, but I am getting a new front valve cover because mine is peeling and awful looking from a guy who lives near me on 3SI... Hrmm I should call him.
__________________
1995 3000GT VR-4 Installed: ESP front precat eliminating downpipe, test pipe, RF-1008 K&N, Dejon tool Y pipe, 1G DSM BOV, MSD wires, Guted rear pre cat, ISSPRO EV Marine boost gauge, IPO MBC, EGR blockoffs, Palm m515 dataloger setup, NGK iridium plugs, SPEC stage II clutch 500ft/lb, 5300k HID plug and play setup. Soon:Topline Engineering ground wires. |
|
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|