Roadmaster 1993 Wagon Leveling System

[bocoogto]

The factory leveling system has always worked well for me. Now, for some reason, the compressor will not turn on. I removed the compressor/motor assy. and checked it on the bench. The motor runs fine, relay works fine. I have a spare switch assy. which I plugged into the harness, but it does not activate the compressor, either. The multi-wired connector to the chassis must be where the problem is. Anyone have further info?

[bocoogto]

Problem was corroded factory wire splice under body on driver's side where the automatic leveling control harness exits the rear floor pan. There is one orange 12 volt #14 wire spliced into four #18 wires. This splice had been factory soldered and taped, but water and salt did a job on it.

I used a butt splice filled with silicone rubber and taped thoroughly. Hope this lasts!! It's probably a common problem on Roadmaster wagons in the snow belt.