 |
 |
 |
|
|
 |
| Search | Car Forums | Gallery | Articles | Helper | Quality Dog Food | IgorSushko.com | Corporate |
 | | ||
| |
|
| Latest | 0 Rplys |
|
|||||||
 |
 Show Printable Version |  Email this Page | 
Subscribe to this Thread
|
|
|
Thread Tools |
11-18-2004, 10:45 PM
|
#1 | |
|
AF Newbie
Join Date: Nov 2004
Location: League City, Texas
Posts: 3
Thanks: 0
Thanked 0 Times in 0 Posts
|
'96 4x4 Yukon Ball Joint help
I am going to tear into the front end tomorrow to replace the lower ball joints, and maybe the uppers too if they are worn. Can anyone walk me through the process? They've been replaced before so I wont have to deal with rivets. I am going to get the ball joint puller from autozone, and maybe a pickle fork. Anything that ya'll can tell me about it would be appreciated.
|
|
|
|
|
11-19-2004, 01:05 PM
|
#2 | |
|
AF Enthusiast
Join Date: May 2004
Location: Bicknell, Indiana
Posts: 1,135
Thanks: 0
Thanked 2 Times in 1 Post
|
Re: '96 4x4 Yukon Ball Joint help
make sure you have a press for the lowers to press em out and back in again. Tighten the press on it and then give it a good whack with a hammer and then tighten it again and whack it again....continue untill it is out. Have fun these can be a bitch. But if they have been changed before it shouldn't be as bad.
__________________
Matthew Brough  1997 Geo Prizm -- 301,000 miles 2000 Honda Accord -- 225,000 miles 2004 GMC Yukon XL -- 223,000 miles 1987 Jeep Comanche -- 116,000 miles  |
|
|
|
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
