Dash LEDs don't work.

[movin2stereo]

The LEDs for the shift indicator and the milelage decided to go black.Anybody have this problem before?This is on a 98 ZR2 and the rest of the lights work and the gauges too.

[BlazerLT]

Check for a blown fuse.

LED's for mileage and shifting?

Can I see a picture of this.

[movin2stereo]

I don't think it would be a fuse considering the rest of the cluster works.As far as a picture of the LEDs,did I mention that they didn't work now?Besides I think your S10 has the same setup,the LEDs are green in color and read P-R-N-D-3-2-1 and of course you know what milelage looks like.Can't describe it any better than that.

[movin2stereo]

No Blazerlt your S10 doesn't have it.Just watched the video after you dumped water in your engine.

[thejacobhartman]

try removing your cluster and check all your connections. the display is not led's but a flourescent diplay. if that doesn't remedy it and you are handy with a soldering iron, open it up and check the connections around the glass portion on the bottom. the display is lit up by a dc voltage with an a/c reference. if either one of these lines is broken it will go dim

[movin2stereo]

Well it came on for a couple of weeks and now is out again.These lines you talk about.Are they part of the circuit board or are they part of the hundred that rise up the display?

[thejacobhartman]

check them right where the display meets the board, there and where it plugs into the harness is where connections usually go bad. i have had to swap my whole cluster due to water and and found one for 50 on ebay. the mileage was close but i had to fill out a sticker and put it inside the dooe with the mileage at the time i took out the old one and what it was on the new one

[movin2stereo]

Thanks I'll check it out.

[movin2stereo]

Checked it out today.It was the wiring harness plug.Thanks.