|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
05-03-2004, 06:33 PM
|
|||
|
|||
|
Flywheel Installation Cost?
Could anyone give me a rough estimate on what it would cost to install a new flywheel in a '92 Mustang? I know there's a lot of labor, but I have a feeling I'm getting jacked. Thanks.
|
|
#2
05-03-2004, 07:36 PM
|
||||
|
||||
|
Well it all depends upon labor rates which can range from $50/hr - $80/hr. I'd say anywhere from $300 - $500 parts and labor.
__________________
92 Mustang GT, 347 Stroker(Forged Steel Crank/Rods-Balanced, Forged Alum Dished Pistons), B50 Block, Track Heat Intake, Twisted Wedge Heads w/ Stage 3 port/polish, 80mm C&L MAF, FMS 30# Inj., BBK AFPR, Trick Flow Stage 2 Cam, Trick Flow 1.6R Rockers, BBK EL-CC Headers, MAC O.R. H-Pipe, Flowmaster Cat-Back, Accufab 75mm TB, MAC CAI, BBK Pulleys, Griffin Alum Radiator, Mark 8 Fan, MSD Pro-Billet Distributor; AOD, Dynamic 3300 L-U Converter, B&M Trans Cooler; 3:73 gears.
|
|
#4
05-03-2004, 09:06 PM
|
|||
|
|||
|
Re: Flywheel Installation Cost?
yea its not that hard, you jus gotta kno how to use tools, and remember how you took it apart, drop the drive shaft, undo the tranny bolts from the block, get a trannmission jack put it under there, and undo the cross member and wiggle it out
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
