NEXT MODS any suggestions

[IH8RICE]

i drive a 1995 GTP with only a shift kit and tranny cooler done to it because the tranny blew up so i had this one rebuilt the right way, im thinkin magnaflow 2.5 exhaust all the way back high flow cat and mufflers, K&N cold air intake and a jet chip will be the next mods for the grand prix prolly KYB struts too ne one got any other suggestions. on what i should get, i know chip and exhaust are comming 1st.

[JoeJoe231455]

Originally Posted by IH8RICE

i drive a 1995 GTP with only a shift kit and tranny cooler done to it because the tranny blew up so i had this one rebuilt the right way, im thinkin magnaflow 2.5 exhaust all the way back high flow cat and mufflers, K&N cold air intake and a jet chip will be the next mods for the grand prix prolly KYB struts too ne one got any other suggestions. on what i should get, i know chip and exhaust are comming 1st.

I'm not sure what motor is in a 95 gtp, I think it is the 3.4 dohc right?

I would put the cold air intake setup on it, and spray the thing with a 35 or 50 shot. Any more than that and I'd be worried for your motor. I doubt you will pick up much hp per $ on that exhaust but if your going for sound it may be worth it to ya.

[IH8RICE]

yeah i have the 3.4 i don't know about NOS yet i wanna get the basic engine mods done first, the more air i can pump in and out of it the more hp ill be making so intake exhaust and chip are comming 1st, but they will be on hold fo a while now cuz i gotta repaint the car cuz some one hit me at school and i dont know who it was so i need a new drivers side fender and repaint the front clip, sucks i only have liability
so its gonna get painted wheels tires intake chip and exhaust hopefully bythe end of may.

[kilroypr]

Well, in my case since the engine and tranny are still under waranty I did not changed any internals on those parts for my 98 GTP. I changed the intake, exhaust and car driving temp. I optimized the coil sparks with 8.5 MM cables.
So the best you can do without spending a whole lot would be the following, to my humble understanding, Do the Intake(CAI and if possible port the intake plenum and heads), POrt the exahust manifold or better yet install headers if they are available. If you have means to find the Jet chip for the car let me know, I have a 93 Z-34 and tought that no chip was available for it. Install a 180 degf tstat to keep all in good shape. Since you had the tranny cooler you should be alright.

[IH8RICE]

i believe that jet has chips for that car and maybe hypertech i know jet has one for my 1995 3.4 liter check those 2. some other sites are rsmperformance.com, domesticperformance.com and planetperfornace.com are a couple i know of ill see if i can find more for your car.