|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
02-17-2004, 11:00 PM
|
||||
|
||||
|
ABS Diagnostic Error Codes (how to flash codes)
Researching the ABS system on ALLDATA, I found the following:
"The EBCM can display diagnostic trouble codes only when the 'Diagnostic Service Mode' has been entered. There are two ways to enter the diagnostic service mode: using a TECH1 scan tool or observing Anti-Lock warning lamp flash codes.The use of a TECH1 scan tool is recommended for diagnosing ABS faults." 1) How do you set the system up to display codes via the warning lamp flash? I was unable to find any information to accomplish this. 
|
|
#2
02-18-2004, 01:15 AM
|
||||
|
||||
|
Re: ABS Diagnostic Error Codes (how to flash codes)
Listed in a previous thread and I asked it. You can not display the codes via the warning lamp flash. The only way to pull the codes off the Aurora is a scan tool. Sorry to disapoint you.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
