|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| '88 - '91 Civic | CRX | Wagon | Shuttlee Partnership with: LadyNRedSi.com |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
12-28-2003, 08:20 PM
|
||||
|
||||
|
Question On Fuel Pump?
My question is I am leaking some gas out of, well, I think its the fuel pump, but I dunno. Its the little module that sits towards the top passenger side of the firewall. It has a banjo bolt on it. I looked in the almighty "hanes" manual and it said that should be torqued at 16 ft-lbs. Well i had it torqued even more that that and it was still leaking. I didnt see any brass washers or and gaskets when I took this off when I did the engine swap. Do I need to get some? If so, are they brass or are they gaskets?
|
|
#2
12-28-2003, 08:32 PM
|
||||
|
||||
|
Re: Question On Fuel Pump?
That is the fuel filter. Might as well buy a new fuel filter as it comes with new brass crush washers, that should solve the problem.
|
|
#3
12-28-2003, 10:18 PM
|
||||
|
||||
|
Re: Question On Fuel Pump?
There should be 2 washer on each connection @ the f/filter
http://www.binghamtonlife.com/manual.../91-11-108.jpg Throw your manual away & get a real one - www.helminc.com
|
|
#4
12-29-2003, 10:29 AM
|
||||
|
||||
|
Yea, I am gonna. It was joke. But I know, Hanes SUCKS ASS. They barely give you any info. For an example, I had to disconnect the shifter linkage and it says, "Remove the pin." Thats it. What a waste of money.
|
| ||||||||||||||||||||||||||||||||||||||
|
POST REPLY TO THIS THREAD |
 |
|
|
