89 Cutlass Supreme stalling

Kscha41 · 11-13-2010, 08:11 PM

Hi I'm new to the board. I hope you guys can help me out. I'm trying to help out a friend get her car running again. Here's the problem. I guess the car is stalling out a lot especially when it warms up. She says it starts right up again after it stalls. It also will not go over 2000 rpm. She says it doesn't stall at 2000 rpm but it acts like it is being governed. We have replaced the IAC and the throttle position sensor and that didn't help. The car has the 2.8 ltr motor in it. Thanks so much in advanced.

maxwedge · 11-14-2010, 09:41 AM

Welcome to AF. First you need to scan for codes, then test the fuel pressure when it dies out.

Kscha41 · 11-14-2010, 09:48 AM

Quote:

Originally Posted by maxwedge

Welcome to AF. First you need to scan for codes, then test the fuel pressure when it dies out.

Thanks for you response. How do I scan for codes. I know autozone won't scan anything older than a 96 or 95. As for the fuel pressure, what am I looking for when it dies.

elca69 · 11-14-2010, 10:26 AM

I've had trouble with ignition module and coil packs acting that way on a 3.1 engine...Good Luck

Kscha41 · 11-14-2010, 03:06 PM

Well I rented a fuel pressure tester today. I hooked it up to the car. Once I hooked it up I turned the ignition on but didn't start it. It first went to 40 psi then went down to 36 psi. Once I started it up it went to 44 psi and it ran like crap. It wouldn't rev up. It would just die. Then after starting it up a couple of times it went to 37 psi and ran great. It would rev and run. It would even run great when warm. But once the psi went up to 44 psi even when warm it would chug and die. So now I am thinking it may be the fuel pressure regulator.

inafogg · 11-14-2010, 03:21 PM

did you check pressure with engine running with the fpr vacuum unpluged??
is the vacuum line wet with gas??

Kscha41 · 11-14-2010, 03:48 PM

Quote:

Originally Posted by inafogg

did you check pressure with engine running with the fpr vacuum unpluged??
is the vacuum line wet with gas??

No I didn't. Where is the regulator at on this car? What would happen with the regulator vacuum line unplugged?

maxwedge · 11-14-2010, 07:49 PM

A no vac situation to the press reg would cause high fuel pressure, it is part of the fuel rail.

Kscha41 · 11-14-2010, 08:06 PM

Quote:

Originally Posted by maxwedge

A no vac situation to the press reg would cause high fuel pressure, it is part of the fuel rail.

Hmm so maybe the vac line is broken or loose. I will have to check before putting a new one on.

Kscha41 · 11-14-2010, 08:35 PM

Well doing some more searching online, its looks like the reg is between the two rails, dead center of the engine. It also looks like you have to take off the intake manifold to get to. Does anyone know if this is true?

maxwedge · 11-15-2010, 08:55 AM

Upper intake must come off.

Thread Thread Starter Forum Replies Last Post

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
93 Cutlass Supreme SL Stalling	eyeintheskyfthp	Cutlass Series	5	08-12-2010 02:49 PM
Cutlass Supreme - which power steering fluid	serge_saati	Cutlass Series	1	12-07-2009 08:15 AM
1992 oldsmobile cutlass supreme stalling	LenInEdmonton	Cutlass Series	8	07-28-2006 10:57 AM
91 cutlass supreme stalling problems	nolimitsoldier	Cutlass Series	2	01-08-2005 12:32 PM
1996 Cutlass Supreme Stalls	shleprock	Cutlass Series	1	01-23-2004 02:35 PM

GET HEALTHY AFFORDABLE DOG FOOD

DEVELOPED BY THE AUTOMOTIVEFORUMS.COM FOUNDER & THE TOP AMERICAN BULLDOG BREEDER IN THE WORLD THROUGH DECADES OF EXPERIENCE. WE KNOW DOGS.

CONSUMED BY HUNDREDS OF GRAND FUTURE AMERICAN BULLDOGS FOR YEARS.

NOW AVAILABLE TO THE GENERAL PUBLIC FOR THE FIRST TIME

PROPER NUTRITION FOR ALL BREEDS & AGES

POST REPLY TO THIS THREAD