 |
 |
 |
|
|
 |
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Dog Food | IgorSushko.com | Corporate |
 | | ||
| |
|
| Latest | 0 Rplys |
|
|||||||
 |
 Show Printable Version |  Email this Page | 
Subscribe to this Thread
|
|
|
Thread Tools |
12-07-2004, 06:13 PM
|
#1 | |
|
AF Newbie
Join Date: Dec 2004
Location: Toledo, Ohio
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
|
350 Head Installation
I am installing a new set of heads to my 350. I have all the new gaskets for the install but am not sure about the proper instalation method.Are there some tricks that would help in the install. What steps should I do to make sure the job is done right the first time. Thanks for any input!!!
|
|
|
|
|
12-08-2004, 04:57 PM
|
#2 | |
|
AF Newbie
Join Date: Oct 2004
Location: pulaski, Tennessee
Posts: 8
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: 350 Head Installation
Always make sure the block surface is clean and the heads are clean. I use a non hardening sealant and torque to 60-70 ft.lbs.
|
|
|
|
|
|
12-12-2004, 02:42 PM
|
#3 | |
|
AF Regular
Join Date: Apr 2004
Location: Modesto, California
Posts: 289
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: 350 Head Installation
use proper torquing process though. dont just tighten the head bolts down to 70 ftlbs. When torquing bolts you need to go in steps like: 25ftlbs to all the bolts(in proper sequence), 50ftlbs, then 75 ftlbs. You can warp the heads if you dont do this.
__________________
1973 Camaro AFR 195cc heads CNC Motorsports 383 short block Comp Cams hyd flat tappet TH350 Dual 3" exhaust (LOUD) Corporate 10 bolt w/ all new internals and axles |
|
|
|
|
|
|
POST REPLY TO THIS THREAD |
 |
| Thread Tools | |
|
|
