here is what i did, learned from reading post
put the decal in warm water and some soap, after you cut it, when is ready to put on, brush the place where you'll place the decal with microsol, then put the decal on top, and with the same brush with microsol, spread the decal, so you dont have as much wrinkles, and i didnt had any bubles, i let it dry for a little bit, and since i was testin it, on one side i brushed it again, and thats where i destroyed the decal, the other side of the intake was fine, couple of wrinkles, but way too small to notice in a finished car..
now, after tons of trying without microsol i can tell you is way way better with it, before i couldnt finish the back of the seat, i heated it
a lot better now
i dont have my digicam to take pics
i was only testing it, thats why i destroyed the carbon fiber decal, now i know how far i can take it next time
