Quote:
Originally posted by flyonthewall
Its not bad at all. I would say though that its not a good idea to use a dremel to cut away bonnets, doors etc. What you could have done is to replace the plastic u cut away with strips of thin styrene glued to the sides of the bonnet, then trim and sand them to fit.
The engine certainly makes the model alot more interesting but it's obviously too small, you could have used styrene again to bridge any gaps.
good job though
|
I tried the razor teqhnique, but I couldn't get around the tight turns of the front of the bonnet, so I busted out the Dremel. Thanks for the tips. BTW, are your CF decal sheers bigger than SMS? I know the price difference is a lot, and you can get 3 of yours for the price of 1 SMS, but I may end up ordering from them to get them faster and avoid oversea shipping costs. Thanks for the tips too.