|
I m not that great modeler, but I found out that if you have already the basic holes and you want to make an even wide gap of it, like the intake, just take some 400-grit or so sandpaper and roll it like it makes a quite hard tube that fits in the hole and gently push and pull it out of the gap untill you have the perfect round shape .
as for the contour of the scoop, I don't know, maybe try to put a panel line around it by using an x-acto knife, first very getly then scribing along the lines...
Hope this info is of any use, and if not, feel free to correct
ciaoo olivier
Last edited by bigfrit; 01-27-2003 at 03:55 AM.
|