Quote:
Originally Posted by Schurkey
Bleeder valves look sorta-kinda like grease zerks. They serve completely different purposes, they are not interchangeable.
Front is 10 mm. Rear is 8 mm.
Might as well stay on this thread. IF (big IF) you can find the proper studs, that'll be way easier than replacing the hub. Good luck finding the proper studs.
|
I should have realized the bleeder valves were metric. I thought the minivan was partially SAE because of its age. Is everything on it metric?
Why do you think the wheel studs will be hard to find? I seemed to have found them with a quick search. Dorman Wheel Stud 610-254.1
https://qrcd.org/3bpv
One other question: Since I need to remove the brake disk & caliper in order to access the hub well enough to replace the studs, what size is the hex wrench on the slider bolts of the caliper? I haven't figured out how to look up bolt sizes unless I get lucky in a search.