The interior is fairly simple. The seats are molded to the chassis. I used some old Testors for the blue on the seats. The shifter is a straight pin cut down to fit; provided by the kit.
The dash has some nicely molded in detail, so I hand painted it with silver and gray and used clear gloss for the gauge faces. I didn't see the need to make gauge decals since visibility is limited through the windows. Getting the dash to line up with the windshield opening was fun. A tiny drop of 5 minute epoxy was used to tack it into place while the body was on the chassis so I could slide it around until it was properly positioned. Then it was reinforced with CA after it was dry enough to remove.
I did the wood grain on the steering wheel a bit heavy to show up through the windows when it is assembled.
