Quote:
Originally Posted by BVC500
impressive! can't wait to see more.
|
Since you're asking
Over the weekend I started printing. First finding the correct angle so I don't have any layer lines. And also making small adjustments to make it fit.
I ended up in printing vertically. It takes five and a half hour... but the result is at it's best.
Then another test fit
I made the final changes to the model so it falls nicely withing the hood boundries. I also included a small indent in the nose section where you can stick your fingers in to reach the release lever.
This is the final render (hopefully) and I can print it one final time.
Arno