[Frah2o]

While I wait felt and rollcage, i started the work on door cards.
First job is to correct an hachette error. The kit has diveided door (metal) from inside structur (in gray plastic). Hachette thinked that was part oof door card......on 1:1 golf is part of the door all metal and one-piece. So i "welded" the 2 part with ciano and bicarbonate.
I also stated the work on door cards: i lowewered on front and rear cards the armrest to permit the fitting of a new flat styrene panel.
I tryed to imitate the carbon door cards of Carbontech
I make 4 hole.
2 for inside cable to open door
1 to apply the belt to pull the door
1 for glass cranck.
The metal wire and yellow belt is only to show...not necessary the final combo material/color

FInally i worked the panel, painted in black and final carbon decal. I'll decide if mantein black pillars or coat also with felt.
A first primer coat to doors to watch some details that need to rework.