The front control arms are cast in Zamac as the exact same parts for both sides so the sway bar receiver (on the upper arm) ends up being different from side to side instead of mirror imaged. So I filled them in and reshaped and drilled them to accept the sway bar.
Also the shocks snap onto the lower arms leaving the bottom of the shock eye open, not realistic but easy to assemble. To make it so I can install closed loop shock eyes I cut out the mount from the A-arm and drilled a hole to use hardware like the real cars. I added a brass section to beef up the parts before cut out the shock mount, and to make it look like the beefier optional part.
Before:
After:
