[Kjenjak]

I started the seats by filling the lower parts with white resin to give them a good base to stand on, and also used putty to repair the damages on the side, that happend while cutting them out of the floor.


I cut off the lower front part to create the right form. The fishbone pattern on the seat parts are filled with putty.




I glued a single sheet of paper towel tissue onto the plastic, to create a surface that looks like cloth.
These cushions are now painted blue. The black stripes are pieces of decal cut to size. In the end the cushions are covered with semigloss clear, and masked.




Now the seats are painted flat black, the sides and the rear are now also masked, and the remaining surfaces are painted again with flat black and micro balls for the Alcantara look.



The side and rear parts are now covered in C/F.