[Talon69]

Originally Posted by rhandwor

I would try unplugging the flasher unit if this stops the bleed I would replace. Other try removing the hazard relay. If this stops the bleed replace.
You can use a DVOM set to milliamp scale. With the ground disconnected measure draw as each fuse is pulled. Any draw above 35 milliamps will drain a battery. When fuse is found use a wiring diagram and one item at a time until problem is found. This is the way I found a bad ETACS unit on my vehicle.

i will try the flashers as soon as i can locate them. They seem like they are below the steering column some where? Also this morning i took the bulb out and the blinker will blink super fast, at least she has a blinker for the rear and mirror now. I turn the 4 way flashers on and the left side will blink normal except the front of course. So then i turn the 4 way off put the light back in the front and it stays on but the rest of the left side will blink now, strange. I had to take the bulb back out tho because it still just stays on when you shut the vehicle off. I have read that similar issues and them people had the IPM replaced and the problem went away. Boy i hope that is not my issue.