View Single Post
Old 11-27-2016, 08:30 AM   #3
j cAT
AF Fanatic
 
Join Date: Oct 2007
Location: EVERETT, Massachusetts
Posts: 10,898
Thanks: 8
Thanked 432 Times in 431 Posts
Re: Deactivating the DOD with programmer

Quote:
Originally Posted by 327chevy View Post
I'm just about at the end of my rope with the oil consumption on this truck of mine,'08 Silverado w/5.3 at 124000 km using 2 to 3 quarts of oil between changes.From what I can gather using an engine flush and deactivating this system is the only cure so I want to know from those that have done it which programmer did you use or which one(s) are capable?
the use of these https://www.amazon.com/Range-Technol...sabling+device does work so the engine stays in V8 mode which then eliminates the engine damage. I would try it and see if the oil use drops. also you must use dexos GM approved engine oil if not then this does occur at a much lower mileage. had a guy with a 2013 65K miles with this problem use some synthetic mix oil rather than dexos spec. if you did not use the dexos oil spec I would buy that DOD tool and also put 5 OZ of MMO into the engine oil and change the oil after a few hundred miles to remove all the sludge which it is reported causes the oil to burn off because of plugged up drain back issues . MMO =marvel mystery oil........post back if it works out .. you have lots of fellow GM truck owners with these issues GM should be sued .
j cAT is offline   Reply With Quote