[hammer2]

Was driving behind a farm tractor and went to put on hazard lights and didn't come on. Nothing in dash and no noise. Shut them off. When tried to put turn signal on, they didn't work. Checked fuses and there was one labeled turn signal and one labeled hazard-both tested fine. Pulled flasher and trying to test, but when trying to see which lead of the 3 is hot, found none of them are? I don't really understand how 3 pole flasher works but from my reading I would think one wire should be hot at all times? Or at least one has to be hot when put a signal on? But nothing is hot.

The wipers and washer work fine. Still could be multifunction switch? But signals worked fine till I tried to put on flasher, now they don't work? Perhaps wires loose near hazard switch?