[glennrmstrng]

I got it. There are several post talking about putting in a resistor to match the resistance of the ECM and insert it to complete the loop. I got my reading with a multimeter by touching my stripped back black wire and either the yellow or orange one on the ignition that runs to the security box. I got a reading at 621 Ohms. The closest I could find to that was at RadioShack and was a 680 ohm resistor. I clipped the yellow wire entirely and stripped back the orange one. I crimped my connections. One end of the resistor went to the orange and the the other to the harness side of the yellow. At this point when I turned the key over to the on position my security light flashed so I let it sit and proceeded the "relearn" instructions. After the 3rd 10 minute wait it fired up