|
Re: Torqing wheels
Unless there's something really wrong with the hardware, you can just twist the torque wrench and if it gets to the FACTORY specs, it's at least "minimum tight".
It may very well be torqued beyond the values the factory wants--which is pretty common, and that's not a good thing either as it stresses the hardware some.
Don't get too worried, as this area is generally overbuilt, because the factory assumes that mindless gorillas will be working on the car.
If you don't trust the other people, back the nuts off to where they are a tiny bit loose and re-torque them to FACTORY SPECS using a criss-cross pattern. Be sure that the wheel is partially supported by a jack or off the ground if the wheel actually comes loose--to make sure that the nuts all have a chance to snug up equally.
|