With help from the Seco Alarm Co I finally figured out how to program my new Remote for the door locks / alarm in my car. If anyone is interested here is what it takes.
The remote for my receiver is designed with traces on the circuit board that are either jumped or cut to form the address of the receiver. I was able to determin what traces needed to be cut by looking at the other working remote I have and copying that. I used a no11 exacto knife to cut the traces. Why the remote was not designed with a mini switch block instead I will never know because that could have been done. It may have made the remote a litter bigger but much easier to program.
Problem solved
Thanks to all of you that gave your input. It was much appreciated.
George