Hi all
well I got the bodywork painted and used a paint I've not used before zero paint. Its a great paint but you don't get the gloss shine I would of liked, so I took the paint off after I tried to go over it with a gloss finish being oil based bad idea it reacted with the zero paint and so the lot went in the soak so the bodywork has to be done again only this time I will be using Humbrol gloss paint. I managed to get my ref book so I could get on with the rest of the machine so here are a few pic's of where I'm at.
Engine and frame setup but more to be done here.
The forks and wheel which I've added some detail and modified a few bits.
Here I've made a valve out of ali and copper tubing.
You can see it better here on the rear wheel.
well that's all folks till the next time thanks for your interest and comments see ya
Clive