Ok..not finished with all rest but just wanted to let you know a few things. Dielectric grease was applied, the dist. is moving, p/u coil properly seated , resistance of p/u coil 758 ohms.. Now I'm checking "C/+" from ign. coil connector? Or the dist. connector? Just wanted to be clear..I have 11.85 on all 3 from ing. conn. "+" "C"& Ing. Only 4.95 on "C" and 0 on "+" from conn. to module. So getting ready to try this other test going ...seem like it's going to be difficult. Also needed to know if spark plug wire w/ spark plug will work , I don't have spark tester around. I just remembered I tested the 4wire harness w/key on and get power to all but 1 "B". Just wondering if ign. switch on steering column has any of the wires for this ..wouldn't mind checking out a diagram of that..just to look.