Thread: Do I need to replace my ignition cylinder?
View Single Post
  #2  
Old 01-21-2014, 08:04 AM
rhandwor rhandwor is offline
AF Enthusiast
  
Join Date: Sep 2006
Posts: 4,662
Thanks: 0
Thanked 64 Times in 64 Posts
Re: Do I need to replace my ignition cylinder?
Quote:
Originally Posted by ASJT3 View Post
So...on my '90 Sierra 305, the ignition cylinder tumbler has always been pretty loose, allowing me to take the key out while running the car. About two months ago I noticed that I was able to turn the ignition cylinder without even inserting a key (which was hilarious and also super-convenient).

After forcing the cylinder to turn without a key, I started to notice some binding and from time to time I would have to re-insert a key to get rid of the binding.

Now, I can't start the truck - she gets no fuel. I suspect this has something to do with the forced ignition. The truck ran and drove fine up until I noticed that it wouldn't start so I don't suspect the fuel pump, although it's clearly not sending fuel. I think that the ECU is not getting switched on.

Will a simple ignition cylinder replacement solve this problem? Does the ignition wire from the ECU wind up through the steering column to the ignition cylinder?

Thanks,

Alex
Their is a rod from the ignition cylinder to the ignition switch on the steering column.
Does the starter turn over?
Reply With Quote