[SeanyG]

Nearly there with the motor now. Most of the assembly is finished with only the coolors to add. I decided that the Turbo Waste Gate unit that sits on the top of the engine was lacking in detail compared to the 1:1 car and because it is so prominent it needed re-doing...



details were made from plastic card and the bolts were from zip tie wire and fuse wire coiled around the zip tie wire. Other bolts are from RB Motion...





With everything in place the motor is now almost complete, I have added the plug leads to one side and also some anodised hoses that sit at the front on the motor, these were all scratch made...







thanks for all your kind comments, more coming soon