[Plata]

hi bro, well, you could save the readings of the transmission and any other module in your computer while you drive, just in case is neccesary.

now, i have to ask,you scan if for troubleshooting something or just for curious?

if you do it for troubleshoooting, you could also post the symptoms.

an a little recomendation for the forscan, you could scan and store the following parameters of the transmission if you want trouble shooting somthing:

-TCC status
-TCC solenoid status
-Input shaft RPM
-Output shat RPM
-Status of three shift solenoids (i see that you have scanned that yet)
-Desired gear (it says somthing like that)
-Desired ratio
-Detected ratio (this last two comes int this format 2.771:1 for example)
-Desired slippage
-Detected slippage
-Temperature

with al that parameters you could properly diagnose your transmission i do it, because i fell mine go to neutral when it should go to third, or somtimes i felt a little slippage in third, so i scan it and doesnt have DTC, then i see this tree paramters.

Desired gear: 3
Desired ratio 1:1
Detected ratio 2:1 varying to 1.5:1 if i dont accelerate hard, also on the test i accelerate hard and then a DTC was stored, it was "incorrect ratio in third gear"

let me found and application chart of the solenoids in the AXODE/AX4S that i sotred in my computer when i was rebulding my tranny, it should be there in some place.

Greetings