[stevenoble]

Did you clean the surface of the decals before you sprayed the 2k clear..?? If you have any form of contamination it will make the fish eyes that you speak about. You can actually add some anti fish eye into the 2k to prevent this happening. Best is to clean the surface of the decals and allow to dry thoroughly before the clear. I use a little dish wash detergent and warm water, which removes any contaminants, excess decal glue etc. Don't strip the 2k off and start again. If they are not too bad you can allow the 2k to dry and lightly wet and dry the surface back carefully till you remove the fish eyes. Then thoroughly clean the surface, allow to dry and re shoot more clear. Provided the surface is contaminant free, you shouldn't have any more problems..