[Plata]

hi, thank you for answering, well, i haven't checked out the van today, becuase the exhaust of my other vehicle was broken and making awful noises, so i have to repair it until i can get the windstar again to the roads.

Well, i could see in older posts that this servo was a little problematic because it doesn't apply the correct pressure causing the low drum to slip, i think my case was different because in my case the low drum stays stopped, so i think that the servo was aplying pressure always, and well, the pressure that controls the servo, for disengage it could be acumulated and also the excesive pressure could cause the bolts threads to break out.

Well, i need to verify how is the servo, and in all case replace it, i see that sonnax make the C-Clip for replacing the OEM clip, but well i first nedd to verify how is the servo piston and cover

thank you

Greetings