Anybody use the generic hangars from Autozone? They are similar to this one, I believe they measure 2" center to center on the holes, which is what I'm measuring on the car. Perhaps a bit narrower than the originals also, though I don't think that will be a problem. I'm a bit concerned about getting them over the mushroom on the hanger, the holes could be slightly smaller than the original. The 3A/Racing site says none of their hangars fit my vehicle. 3A/Racing 17163.
http://www.autozone.com/autozone/acc...ier=58088_0_0_
Here is another model they have, 17219, not quite sure what is different about it. I will probably take a look at these at the store later today.
http://3aracing.com/pdut_detail.asp?ID=472