Removal
VIN "S"? 8th didgit of VIN. I'm gonna say it needs to come off...
1. Remove the LH
exhaust manifold to pipe nuts.
2. Raise and support the vehicle.
3. Remove the front RH wheel.
Zoom and Print Options
4. Remove the RH front inner wheel splash shield.
- Remove the screws and the pin-type retainer.
Zoom and Print Options
5. Disconnect the RH Heated Oxygen Sensor
(HO2S) electrical connector.
Zoom and Print Options
6. Remove the exhaust bracket bolt.
Zoom and Print Options
7. Disconnect the LH HO2S sensor electrical connector.
Zoom and Print Options
8. Remove the RH exhaust manifold to pipe nuts.
9. Support the
exhaust system.
Zoom and Print Options
10. Remove the nuts and the Y-pipe.
- Discard the gasket.
11. Drain the
engine oil.
- Install a new drain plug gasket and tighten the drain plug to
27 Nm (20 ft. lbs.).
Zoom and Print Options
12. Remove the bolts, nuts and the
engine to transaxle bracket.
Zoom and Print Options
13. Remove the torque convertor inspection cover.
Zoom and Print Options
14. Remove the 18 bolts and the oil pan.
Installation
1. Clean all sealing surfaces on the engine and the oil pan with Metal Surface Cleaner F4AZ-19A536-RA or equivalent meeting Ford specification WSE-M5B392-A.
2. Position a new gasket on the oil pan.
Zoom and Print Options
3.
Note: The oil pan must be installed and the bolts tightened with in six minutes of sealant application.
Apply a
10 mm (0.40 inch) diameter dot of Silicone Gasket and Sealer F7AZ-19554-EA or equivalent meeting Ford specification WSE-M4G323-A4 to the areas indicated.
Zoom and Print Options
4. Position the oil pan and hand tighten the oil pan to transaxle bolts.
Zoom and Print Options
5. Tighten the oil pan bolts in the sequence shown
Zoom and Print Options
6. Tighten the oil pan to transaxle bolts.
Zoom and Print Options
7. Install the torque convertor inspection cover.
Zoom and Print Options
8. Position the engine to transaxle bracket and install the nuts and the bolt.
Zoom and Print Options
9. Position the Y-pipe and gasket and install the nuts.
Zoom and Print Options
10. Install the RH exhaust manifold to pipe nuts.
Zoom and Print Options
11. Connect the LH HO2S electrical connector.
Zoom and Print Options
12. Install the exhaust bracket bolt.
Zoom and Print Options
13. Install the RH front inner wheel splash shield.
- Install the screws and the pin-type retainer.
14. Install the RH wheel.
15. Lower the vehicle.
Zoom and Print Options
16. Install the LH exhaust manifold to pipe nuts.
17. Fill crankcase to proper level with Super Premium SAE 5W-30 Motor Oil XO-5W30-QSP or equivalent meeting Ford specification WSS-M2C153-G.
© 2012 ALLDATA, LLC. All Rights Reserved.