[ace91]

Gracias, miguel s.

It took me a while to study & understand the brake disc for wet race layout. Your experiment is really good. Keep it up.

Here are the photos of the bike without the fairings attached. As I do not have anymore green wire to put, I have to use the stock wire provided by the kit. Only if Tamiya follows Hasegawa kits that is giving us the transparent wire so that we can either colour it with clear red or green for the wire depending on the placement.











Here are the fairings after colouring them with yellow as base coat before colour them red.



After taking some time to place the decals, here are the photos of the completed bike. The Malboro decal that I used is Hobby Design. Though it has some cuts for it on the fairing part but the one on the right side of fairing have to cut the line otherwise it'll be one whole piece rather than any typical decal piece with cuttings as you see in Tabu Design, Studio 27, etc. The size of the decal on fairings are kind of a little oversize here cause if you can see a photo or two, you can see the excess of the decal on the fairing at the edge there. The Hobby Design Malboro set has missed out one part that is the 3 small Malboro parts that are placed on the screen. Luckily I have some extra from the Museum Collection set that I've used on my previous Desmo bike & they have 6 pieces of the small Malboro part instead of usual 3 pieces.











Comments & suggestions are welcome.

Adrian