[65comet]

Rod, pushing with all my might and trying to turn the cube without it jumping out of the slots is half the fun. (Laughing as I look at the scar on my knuckle from the last time) I take the caliper off, remove the rotor and pads, then remount the caliper so it is held firmly in place. I put my 3/8 to 1/2 adapter in the cube, then a 6 inch long 1/2 extension with 1/2 drive ratchet. This way I have can use both hands for tool alignment and cranking. I've put the good tool on my X-mas list a couple of times, but never got it. Guess I was on Santa's bad list.