Windshield Wiper System Module Replacement
Removal Procedure
1. Remove the wiper arms.
2. Remove the air inlet grille panel.
3. Remove the underhood electrical center.
4. Remove the cruise control module.
5. Disconnect the wiper motor cover electrical connector.
6. Remove the wiper system drive module bolts.
7. Remove the wiper system drive module from the engine compartment.
Installation Procedure
1. Position the wiper system drive module to the cowl.
2. Install the wiper system drive module bolts.
Tighten
Tighten the bolts to 9 N·m (80 lb in).
3. Connect the wiper motor cover electrical connector.
4. Install the cruise control module and bracket.
5. Install the underhood electrical center.
6. Install the air inlet grille panel.
7. Install the wiper arms.
Hope this helps!