Quote:
Originally Posted by rusnamps
the replacement pump was a Bosh... I have a Delphi that i plan to replace it with....I also just installed a new presure regulator (major pain in the butt to put in) and filter, the old one seemed semi clean when i cut it open. I hope by replacing the pressure regulator and ground connection my problem will be fixed.
|
with all the different pump manufacturers used, the wiring at the pump and splices into the OEM wiring should be soldered and heat shrink with electrical insulation to insure a good electrical connection for the pump power which does draw a few amps.
the fuel filter should look slightly dark if it has a few thousand on it . remove the filter from the frame and you should see light thru the filter media. it you cannot see any brightness when placing a light at the other side of the media then the filter is restricted. with a filter this little used perhaps the fuel supplier used is to be avioded.