[BajaScout]

After replacing the intake manifold gasket for the second time, the truck would not start. Thought for sure it was my putting the distributer in wrong. After reviewing the forums, I am sure it is installed correctly. I have spark but no start. Engine cranks over nicely, but acts like it needs fuel. I hooked up a fuel gauge, turned on the key and get 56PSI. Lower than the 60 required. The pressure then slowly goes to 50 PSI. I pinched off the return hose and had the same readings. Pretty sure I need to replace the fuel pump. Is there anything else I need to check. I replaced the fuel pump a couple years ago with a Delphi unit. Maybe this is just a weak link for these trucks. My truck has a little over 100,000 miles on it. Appreciate any advice folks may have.